democap:tutorialimportblender
This is an old revision of the document!
Start Page » DEMoCap: Drag[en]gine Motion Capture » Tutorial: Import Animation Into Blender
Import Animation Into Blender
- Run Blender3D.
- Install the Blender Addon Drag[en]gine Import Export if not installed already.
- Select the Armature matching the Rig used for doing the motion capture. The capture directory is located here:
- Linux: ~/config/delauncher/games/e31f1c11-3ca6-c66b-adca-95484bedfc1f/capture/animations
- Windows: %AppData%\DELaunchers\Config\games\e31f1c11-3ca6-c66b-adca-95484bedfc1f\capture\animations
- Click File → Import → Drag[en]gine Resources → Animations.
- Wait for the import to complete. Importing can take from a couple of seconds to a couple of minutes for long captures. In general multiple short captures are recommended over long captures.
- The imported action is named “Imported MoCap”.
You could leave a comment if you were logged in.
democap/tutorialimportblender.1637081931.txt.gz · Last modified: 2021/11/16 16:58 by dragonlord
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
