democap:uipanelsettings
This is an old revision of the document!
Start Page » DEMoCap: Drag[en]gine Motion Capture » UI: Panel Settings
Contains global settings including VR control.
Module Parameters
Shows dialog allowing to change game engine module parameters.
Help (Wiki)
Shows the DEMoCap wiki landing page in the system browser.
Enable VR
Enables VR System. VR System starts out disabled to allow mocap operators to set up the scenes before actors are ready to perform. Once enabled Enable VR View is enabled too.
Enable HMD
not supported yet
Show VR View
If enabled shows the left eye send to the actor HMD in the 3D view. If disabled shows a free navigation 3D camera controlled by the mocap operator.
You could leave a comment if you were logged in.
democap/uipanelsettings.1643582699.txt.gz · Last modified: 2022/01/30 22:44 by dragonlord
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
